Hello and welcome to our community! Is this your first visit?
Register
Results 1 to 4 of 4
  1. #1
    Junior Member
    Join Date
    Mar 2017
    Location
    Utah
    Posts
    14
    Total Downloaded
    0

    Prints not sticking to the bed!

    I have a Monoprice maker select that I just got recently, and for some unknown reason, suddenly nothing will stick to the bed! It's been maddening and frustrating to say the least! How do I fix this and get my prints to stick? I'm just using regular PLA clear filament, extruder heated to 215, bed to 70 degrees.

  2. #2
    Junior Member
    Join Date
    Mar 2017
    Location
    Utah
    Posts
    14
    Total Downloaded
    0
    I've looked around and found that many use painters tape or actually spray a layer of hairspray on the bed. I tried a spray adhesive called Photo Mount that I got from Hobby Lobby. Seems to work for the most part.

  3. #3
    Junior Member
    Join Date
    Mar 2017
    Location
    Utah
    Posts
    14
    Total Downloaded
    0
    Now I'm getting the main part of the prints to stick, but edges are warping up. Do I have the bed too hot? I have it at 70 degrees since 60 wasn't working, but maybe that's too much.

  4. #4
    You have the bed a little too hot. 60 or even 50 degrees should work fine.


 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •